网站首页 关于我们 新闻中心 企业荣誉 产品展示 销售业绩 下载中心 人才招聘 联系我们
HBM-S中央链提升机
HBM-D中央链提升机
HBC型熟料链斗机
HBE型胶带提升机
HBN大型板式链条斗式提升机
NE 提升机
NSE 提升机
FU链式输送机
主要配件-链条
主要配件-链轮
   您当前的位置:首页 - 产品中心
 HBC型熟料链斗机 >> HBC型熟料链斗机
 宏基输送配有精密模锻链条的高温倾斜输送机 HBC型
 
输送能力超过每小时 600吨  
   相临近的两个料斗间的间距较短,料斗的高度很深,料斗的容积较大,使设备的输送能力大大提高,最大输送能力可超过 600吨/小时。( With conveying capacity exceeding 600tons per hour With small bucket spacing, high bucket depth and large bucket volume, the equipment’s conveying capacity is significantly increased, and the max. conveying capacity can exceed 600T/H.)
倾斜角度可超过 60度  
  采用配有精密模锻链条的节距很短,运行非常灵活,可使设备倾斜角度可超过60度,大大节约了运行的空间距离。( Slope angle of over 60 degrees is available Equipped with high-precision forged chains with short pitch, the conveyor can runs at a flexible slope angle as much as more than 60 degrees,and the spatial distance required for conveyor operation is reduced considerably. )
提升高度可超过 55米
   合理的设计、超大的负载安全系数和严谨的制作工艺确保精密模锻链条的可靠的寿命,也确保在高距离提升的情况下能平稳运行。( With very reasonable construction design,the chains of the elevator utilizing precision drop-forged chains reasonably reduce their deadweight but greatly increase their breaking strenght.)

最小曲线半径为 10米
 
超强耐高温,能瞬间承受 400℃的物料温度

   采用耐高温的优质合金特种钢材料,大大降低了在持续高温状态下的热变形,严谨的热处理工艺大大增强了在持续高温状态下的稳定性能。( Provided with full-travel pull switch, speed measuring device, and chain lubricator (optional parts) Full-travel pull switch can provide effective protection for reliable operation of the equipment and increase its service life. The speed measuring device can accurately monitors operation status of the equipment. Chain lubricator can ensure long and safe running of chains.)

配有全程拉绳开关、测速装置 ; 链条润滑装置(设计选用部件)

   配有全程拉绳开关可有效的保护设备的可靠运转,提高设备的运转寿命;测速装置可靠的检测设备的运转状态;链条润滑装置能保护链条的安全长期运转。( Special high-strength buckets are used on the conveyor Special high-strength buckets are used on the conveyor, depending on the physics and chemical properties of handled materials, which can ensure that different high-temperature materials can be transported at optimum efficiency by using appropriate types of buckets. )

配有专用的强力斗型

   根据物料的物理和化学性能配有专用的强力斗型 ,确保不同的高温物料通过相应的斗型达到最佳的输送效率。( C-type sweeper can remove the materials piled at discharge outlet and take-up areas. This sweeper is recommended for transportation of fine powders. )


点击数:100  录入时间:2009/3/6 【打印此页】 【关闭
     | 关于我们 | 联系方式 | 客户留言 | 人才招聘 | 相关知识 | 友情链接 |                   版权所有(2013-2015) 杭州宏基输送机械有限公司 备案号:浙ICP备05051661号